Denon AVR-789 Manuel d'utilisateur télécharger pdf (Page 92)

Placement Options

The MCS 100 satellites and center channel are easily placed on a tabletop or wall-mounted. The

speakers are congured for tabletop use when you rst unpack the system. The foot installed on

the rear of the speaker will keep it upright.

The MCS 100 satellites and center channel are designed to easily mount on the wall using the

keyhole slot(s) on the back of the speaker. When mounting the speakers to the wall use the supplied

rubber bumpers. You must remove the attached foot to wall-mount your speakers. Remove the

thumbscrew from the back of the foot. It is slotted for easy removal with a screwdriver or a coin.

The keyhole mounting option is similar to hanging a picture frame on a wall. Install a #8 screw (not

included) into the sheetrock, making sure to go into a stud, and hang the speaker onto the screw head.

If a stud is not available, a sheetrock anchor should be used to support the weight of the speaker. It is

advisable to connect the speaker wire prior to wall-mounting.

NOTE: Because there are so many dierent kinds of surfaces on which the speakers could be mounted. There is no one

type of fastener that we could supply that would work in all the possible situations. So taking into account the surface the

speaker is being mounted on, acquire the appropriate type of fasteners. If you’re not sure what type of fastener to use, take

the mounting bracket to a friendly hardware store, tell them about the wall you’re mounting the speaker on, and ask them

to recommend an appropriate fastener. Keep in mind the weight of the speaker.

Speaker Connections

After your speakers are properly placed, you are ready

to wire your system. First, turn o all system power.

Use the speaker wire included with the system to

make your connections. For longer distances, #16 or

#18 gauge wire available from your dealer should be

used. Please see the illustration for guidance con-

necting the wires to the MCS 100 satellites and center

channel.

For connection to your receiver please refer to its

owner’s manual.

Important!

To ensure the best performance observe polarities when making speaker con-

nections, as shown in the illustration. Connect each + terminal on the back of the

amplier or receiver to the respective + (red) terminal on each speaker. Connect the

– (black) terminals in the same way. If the connections are not made correctly it can

cause poor bass response and imaging. Also, to avoid short circuits that may damage

your equipment be careful not to let any of the bare wires touch each other.

Subwoofer Connections

Turn o all power. Use the subwoofer cable included with your

system to connect the subwoofer to your receivers Subwoofer or

LFE Output. Connect the other end to the “Line In” on the back of

the Subwoofer.

+ –

12V

TRIGGER OUT

+ Red – Black

1 2 ... 87 88 89 90 91 92 93 94 95

Commentaires sur ces manuels

Pas de commentaire

Denon AVR-789 Manuel d'utilisateur Page 92

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs et amplificateurs Denon AVR-789