Denon AVR-5805CI Manuel d'utilisateur télécharger pdf (Page 123)

123

Advanced Setup – Part 1

• When adjusting the level of an active subwoofer system,

you may also need to adjust the subwoofer’s own volume

control.

• When you adjust the channel levels while in the SYSTEM

SETUP CHANNEL LEVEL mode, the channel level

adjustments made will affect all surround modes for ZONE2.

• After you have completed the SYSTEM SETUP CHANNEL

LEVEL adjustments, you can then activate the individual

surround modes and adjust channel levels that will be

remembered for each of those modes. Then, whenever you

activate a particular surround sound mode, your preferred

channel level adjustments for just that mode will be recalled.

Check the instructions for adjusting channel levels within

each surround mode ( page 95, 96).

•You can adjust the channel levels for each of the following

surround modes for ZONE2: STEREO, STANDARD

(DOLBY/DTS SURROUND), 5/7 CH STEREO, WIDE

SCREEN, SUPER STADIUM, ROCK ARENA, JAZZ CLUB,

CLASSIC CONCERT, MONO MOVIE, VIDEO GAME,

MATRIX and VIRTUAL.

Press the CURSOR

button to select the

frequency.

VARIABLE 40, 60, 80, 100, 120, 150, 200, 250 Hz:

Set as desired according to your speakers’ bass

playback ability.

Press the ENTER button to enter the setting.

• The “Zone Setup” menu reappears.

Setting the Crossover Frequency for ZONE2

• Set the frequency (in Hz) below which deep bass appearing

in the main channels will be routed to the ZONE2 subwoofer.

Press the CURSOR

button to select

“Crossover Frequency” at the “Zone Setup”

menu, then press the

ENTER button.

• The “Crossover Frequency” screen appears.

• For the majority of home theater speaker systems, we

recommend that the crossover frequency be set to 80 Hz.

When using very compact speakers, however, it may be

advantageous to select a higher crossover frequency. Check

the specified low frequency limit of each speaker (usually

published in the specifications tables in speaker owner’s

manuals).

• The crossover frequency mode is valid only when subwoofer

is set to “Yes”, and when one or more speakers are set to

SMALL, as described in section “Setting the type of

speakers for ZONE2” ( page 120).

Press the CURSOR

button to select the

ZONE2 input source, then press the

CURSOR

button to select “ON” or “OFF”.

ON:

When there are multiple input signals for the input

sources selected at ZONE2, the input signal is

detected and the input signal output to the

ZONE2’s monitor output terminal is selected

automatically, in the following order of priority:

Component, S-Video, Composite.

Setting the Video Setup for ZONE2

Press the CURSOR

button to select

“Video Setup” at the “Zone Setup” menu, then

press the

ENTER button.

• The “Video Setup” screen appears.

2 Video Convert Mode (ZONE2)

• This sets whether or not to use the video conversion

function.

Press the CURSOR

button to select

“Video Convert Mode”, then press the

ENTER

button.

• The “Video Convert Mode” screen appears.

OFF:

The convert function does not operate.

In such cases, the input device’s cable type must

be the same as the type of cable connected to the

AVR-5805CI’s monitor output terminal (video, S-

Video or component video).

Press the ENTER button to enter the setting.

• The “Zone Setup” menu reappears.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 213 214

Commentaires sur ces manuels

Pas de commentaire

Denon AVR-5805CI Manuel d'utilisateur Page 123

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs AV Denon AVR-5805CI